40 NAT GAS PWR VENT TTW W/H H=66.875 D=20 V=2OR3

PART BWC RG2PV40T6N

SUPPLIER Bradford White®

SUPPLIER PART # RG2PV40T6N

Calculating price...

QUANTITY

About this item

Bradford White® Defender Safety System® Gas Water Heater, Series: TTW®, 40000 Btu/hr Heating, Natural Gas Fuel, 1/2 in Gas Connection, 40 gal Tank, Pilot Ignition, Power Vent, 2 x 3 in Vent, 43 gph Recovery Rate, 0.68 Energy Factor, 3/4 in NPT Water Connection, 150 psi Pressure, Ultra Low Nox: No, 20 in Dia x 26-1/16 in D x 66-7/8 in H Dimensions, Domestic

Our Power Vent (TTW®) models are power vented for positive exhaust. They offer greater installation flexibility with the ability to vent through a wall or roof, with either 2 or 3 in PVC, ABS or CPVC pipe. They offer an increased amount of hot water available at a usable temperature in less time than normal.

AHRI Certified|ANSI Z21.10.1-2014|ASHRAE 90.1b|CEC Listed|CSA 4.1-2014|CSA International (Formerly AGA/CGA)|CSA LLC - Low Lead Compliant|EnergyStar® Certified|Massachusetts Approved|NSF 372

Dimensions 20 in Dia x 26-1/16 in D x 66-7/8 in H

Domestic/Import Domestic

Energy Factor 0.68

Fuel Type Natural Gas

Gas Connection 1/2 in

Heating Capacity 40000 Btu/hr

Ignition Type Pilot

Pressure Rating 150 psi

Recovery Rate 43 gph

Series TTW®

Tank Capacity 40 gal

Ultra Low NOx No

Vent Size 2 x 3 in

Vent Type Power

Water Connection 3/4 in NPT

Brand Bradford White®

Country of Origin US

Warranty 6 Years Limited on Tank/6 Years Limited on Component Parts

Bradford White® ICON System™: Intelligent gas control with spark to pilot ignition system eliminates the constant burning pilot, this results in savings of pilot gas during stand-by periods (120 VAC)

Enhanced performance: Proprietary algorithms provide enhanced first hour delivery ratings and tighter temperature differentials

Advanced temperature control system: Microprocessor constantly monitors and controls burner operation to maintain consistent and accurate water temperature levels

Intelligent diagnostics: An exclusive green led light prompts the installer during start-up and provides ten different diagnostic codes to assist in troubleshooting

Power vent water heater: Designed for installations where atmospheric units cannot be used, exhaust gases are vented under positive pressure directly out of the building through the roof or the wall

Powerful blower motor: Our significantly quiet design has greater resistance to outside winds and the power to vent in many difficult venting situations

Horizontal and vertical venting: PVC, ABS or CPVC

Advanced ScreenLok® technology flame arrester design: Flame arrester is designed to prevent ignition of flammable vapor outside of the water heater

Flammable vapor sensor: Electronic sensor prevents burner operation if flammable vapors are detected

Maintenance free: No regular cleaning of air inlet openings or flame arrester is required under normal conditions

Sight window: Offers a view into the combustion chamber to observe the operation of the pilot and burner

Factory installed Hydrojet® total performance system: Sediment reducing device that also increases first hour rating of hot water while minimizing temperature build-up in tank

Vitraglas® lining

Insulation system: Non-CFC foam covers the sides and top of the tank, reducing heat loss, this results in less energy consumption, improved efficiencies and jacket rigidity

Water connections: 3/4 in NPT factory installed true dielectric fittings extend water heater life and simplify water line connections

Factory installed heat traps: Design incorporates a flexible disk that reduces heat loss in piping and eliminates the potential for noise generation

Low restriction brass drain valve: Durable tamper proof design

Protective magnesium rod

FVIR defender safety System®

Instruction/Installation Manual

Line Drawing

Warranty Information

Specification Sheet

Service Manual

40 NAT GAS PWR VENT TTW W/H H=66.875 D=20 V=2OR3

About this item

Related Products

Recently Viewed Products